One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
A single-cable fix often means a second failure soon after. We explain the pair-replacement logic upfront.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
A same-day fix is standard for cable failures, parts already on the truck.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
Worn or cracked cable drums get replaced alongside the cable itself, since a damaged drum will fray the next cable too.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
Replacing just one often leads to a second failure soon after. We're upfront about that tradeoff.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
Most cable replacements are completed same-day, typically within one to two hours once the technician arrives.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of San Marcos to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for San Marcos, TX